国产 日韩 中文字幕 制服-色午夜婷婷-黄片 毛片www-黄色三级毛片视频-国产精品自产拍在线18禁-亲近乱子伦免费视频无码-欧美无吗-欧美在线a-免费人成网站视频在线观看国内-日本做床爱全过程激烈视频-红杏亚洲影院一区二区三区-国产免费久久精品99久久-天天摸天天做天天爽-俺去射-国产肉体xxxx裸体784大胆

The problems of the wire drawing machine, is mainly caused by the following factors:
　1during the uninterrupted production, the drawing die size becomes bigger due to the normal wear and tear.
　2. due to the annealing current production is not constant, the current becomes high suddenly, the monofilament in annealing process is broken or strong current by mutant fuse.
　3. because of the quality problems of all kinds of rod material. In the process of production, rod material appeared irregularly quality defects, which makes the filament is unpredictable in the drawing deformation of tension. This occurs less when the rod quality is good.
　Solution: choice the different modes according to the different rod quality, fumble ceaselessly in production. For example, in the production of copper rod production, it required 8 drawing die when pulling the 2.53mm monofilament, when produce the same diameter monofilament, if use a rolling rod, it need to add a bridge mode in distribution mode according to the requirements; we should do the full self-checking with the will produced copper rod before operation, and found the quality defects of the copper rod timely, to find the corresponding countermeasures according to the different situation, or reduce the drawing speed, or will this defective elimination.
　Constantly observe whether the annealing current drawing is normal during the production, especially at the beginning of started, especially attention to the changes of annealing current, we should adjust the size of the current annealing according to the change of line speed, and then the annealing current slowly becomes large with increase of speed change, to ensure the normal operation of equipment.
　I believe that as long as we mainly focused to control the above points in the actual production, the product quality and production efficiency of copper wire drawing will have different degrees of improve, so in can better and faster to provide a strong production security for the next process production.